12 Volt Trail Drill

I've seen write ups on this before, so when I came across this 12v Makita Drill I decided it was a good time to make a portable drill for my Jeep. The concept being that you'll always have a usable drill on the trail, not needing to worry if its battery is charged or if the charge will run out

I found this one on Craig's List for twenty bucks! It came with a flashlight, and a case. No battery, no biggie, I didn't need it anyway since I wired it to work off a 12 volt car battery. I took the case apart and soldered some wire connectors to the battery contacts. Then I attached those to a standard 110v electrical cord prong. Then by plugging that into a spare extension cord with some alligator clips attached, I can now hook up to a battery. I'll make a similar conversion for the flashlight as well and the extension cord can be used to power either device.


In place of the charger and battery in the case I'll load up some drill bits, grinder discs and cut-off discs.

Now I just need to make room for it in the Jeep!







By Flatty Mike